Conventional  Spray Guns

Item # J300C


The J300C is a fine finish gravity feed gun intended for the best possible application in automotive and wood finishing. Features include all stainless steel fluid passages, low volume nozzles for small HP compressor use and self-adjusting needle packing. Comes standard with 750cc aluminum gravity cup. This gun complies with all HVLP environmental regulations.

Custom Built To Your Specs And Independtly Tested!!




Specifications

Material Type Very Thin (inks, dyes, solvents, stains) [less than 16 seconds Zahn#2]
Thin (lacquers, enamels, primers, sealers) [16-20 seconds Zahn#2]
Medium (automotive base coat, enamels, primers, epoxies, urethanes, automotive clear coat) [21-30 seconds Zahn#2]
Heavy (heavy body primers, high solid enamels, high solid automotive coatings, adhesives) [over 30 seconds Zahn#2]

Fluid Orifice x Air Cap x Maximum Pattern Medium - 1.3 mm x 1013 x 11 inches (standard)
Very Thin - 1.0 mm x 1010 x 11 inches
Thin - 1.0 mm x 1010 x 11 inches
Thin - 1.3 mm x 1010 x 11 inches
Medium - 1.5 mm x 1015 x 11 inches
Medium - 1.7 mm x 1017 x 11 inches
Heavy - 1.5 mm x 1015 x 11 inches
Heavy - 1.7 mm x 1017 x 11 inches
Heavy - 1.9 mm x 1019 x 11 inches
Heavy - 2.2 mm x 1022 x 11 inches

Air Inlet 1/4" NPS (m)

Fluid Inlet 16 mm x 1.5

Weight 25 oz.

Standard Setup 1.3 mm x 2013

Repair Kit 10-105